Checking The Battery Status; Changing Tools; Gear Drive; Torque Control / Drill Step - Parkside PABS 12 A1 Originalbetriebsanleitung

Checking the battery status

To check the battery status, press the button for
the rechargeable battery LED
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED as follows:
3
RED / ORANGE / GREEN = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery

Changing tools

Your cordless drill / screwdriver has a fully automat-
ic spindle lock .
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

2 Gear Drive

Note: Move the gear selector switch
the device has come to a standstill.
In the first gear (Gear selector switch
in Position: 1)
you achieve a speed of up to approx. 400 rpm and a
high torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.

Torque control / drill step

You can use the torque control / drill step
adjust the torque. When the value of the torque
Before first use / Preparing the tool for use
setting is reached, the clutch disengages the drive
connection to the chuck.
(refer to main
2
can Unlock the device and change the direction of rota-
11
. tion by pressing the rotational direction switch
to the right or to the left.
, you can immedi-
Switching on:
).
5
only after
1
Switching off:
1
Changing the rotational speed:
The ON / OFF switch
control. Light pressure on the ON / OFF switch
1
causes the device to operate at a low speed. In-
creasing the pressure increases the speed.
to
10
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling work, select the drill setting by putting
the torque control / drill setting into the
For drilling tasks, also push the gear selector
switch to the front (Position: 2).
1

Preparing the tool for use

Changing the direction of
rotation / unlocking the device

Switching ON / OFF

To start the appliance squeeze on the ON /
OFF switch and then keep it pressed down.
5
The light comes on with a slightly or fully
9
pressed ON / OFF switch
the working area in poor lighting conditions.
To stop the appliance, release the ON / OFF
switch .
5
has a variable speed
5

Activating the lock

Press the rotational direction switch
middle position. The ON / OFF switch
now blocked.
position.
4
and illuminates
5
5
into the
4
is
5
GB 31