Screen Saver - OJ Electronics OJ-GreenZone-Module Montageanleitung

OJ Zone Module and Room Panel with 2" Touchscreen

Screen saver

After a given time without activity, the display will switch to a
black screen displaying only the time and temperature setting. The
period of inactivity before the screen saver is activated can be set
by tapping the Screen saver button.
Use the Up or Down arrow to adjust the length of time before the
screen saver starts. The minimum is 10 seconds and the maximum
is 60 seconds. To skip changing the screen saver timeout, tap the
Left arrow without tapping the Accept button. Otherwise, tap the
Accept button to confirm the new setting.
After changing the screen saver timeout, tap the Left arrow three
times to go back to the main menu. In the main menu, tap Home to
exit the menu.
16 © 2015 OJ Electronics A/S
English OJ Zone Module and Room Panel with 2" Touchscreen
Config mode
When Config mode is set to Auto, the system will continuously
update the configuration. The system will therefore automatically
adapt whenever a sensor is added or removed. The system will
also automatically adapt when attached sensors fail. No alarm will
thus be triggered as long as the system is able to adapt.
Always set configuration mode to Auto during installation of the
OJ GreenZone™ Module system. If configuration mode is set to
Manual, tap the Config mode button the change the setting.
After installation has been completed, set configuration mode back
to Manual in order to allow alarms to be displayed if faults should
occur.
After selecting the desired configuration mode, tap the Left arrow
to accept your choice. Tap the Left arrow three more times to go
back to the main menu. In the main menu, tap Home to exit the
menu.
© 2015 OJ Electronics A/S
English
17