Attaching The Feet (See Fig. B); Attaching The Dust Blow Tube (See Fig. C); Bringing Into Use; Setting The Stroke Rate - Parkside PDKS 120 B3 Originalbetriebsanleitung

Assembly / Bringing into use
S lide the blade guard
tion and fix it in that position by tightening the
knurled nuts .
10
Attaching the feet
Q
A ttach the feet
12
mounting holes in the device's base plate.
Attaching the dust blow tube
Q
(see Fig. C)
Screw the fan tube
into the designated opening.

Bringing into use

Q
CAUTION! Make sure that the device is
switched off before you connect it to the mains supply.
A lways switch on the electrical power tool before
moving the workpiece against it. Otherwise
there is the risk of kickback.
Setting up the device:
G rab the device at the position labelled
"Please lift here" to position the device.
Switching on the device:
P ress the green ON button
Switching off the device:
P ress the red OFF button

Setting the stroke rate

Q
T urn the stroke rate controller
increase the stroke rate.
T urn the stroke rate controller
to decrease the stroke rate.
NOTE: Be aware that too high a stroke rate leads
to the saw blade heating up, an increase in wear
of the saw blade and burn marks on the material.
10 GB/IE
into the desired posi-
9
(see Fig. B)
12
from below through the
clockwise and hand tight
1
.
4
.
3
clockwise to
2
anticlockwise
2
S elect a saw speed suitable for the material
being sawn.
Maximum
speed
Thick woo- Straight
den board cut
Thin woo- Straight
den or and curved
plastic cuts
board
1
Tilting the saw table
Q
(see Figs. D, E)
U nscrew the angle setting screw
T ilt the saw table
reached.
NOTE: The angle can be read off the angle
scale .
6 a
R etighten the angle setting screw
Inserting / removing the
Q
saw blade
Pull the mains plug out of the socket before you
carry out any task on the device,
Inserting the saw blade
L ift up the clamping lever
I nsert the saw blade
the saw table
Ensure that the teeth of the saw blade
forwards and downwards.
S uspend the saw blade
blade mount
T hen hook the top pin of the saw blade
the recess provided for this purpose in the top
saw blade mount
L ower the clamping lever
blade .
7
T urn the clamping lever
wise to increase the tension.
Medium Minimum
speed speed
Normal -
fretsaw
work
Normal Intricate
and intri- fretsaw
cate work
fretsaw
work
6
.
5
until the desired is
6
.
5
7
DANGER OF INJURY!
:
7
.
13
through the opening in
7
.
6
in the bottom
7
.
14
.
8
to tension the saw
13
horizontally clock-
13
point
7
in
7