Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Information For Circular Saw Blades; Genuine Accessories/Auxiliary Equipment; Before Initial Use; Charging The Battery (See Fig. C) - Parkside PHKSA 18-Li A1 Betriebsanleitung

Vorschau ausblenden Andere Handbücher für PHKSA 18-Li A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not allow the teeth of the saw blade to overheat.
When sawing plastic, avoid melting the plastic.
Safety information for
circular saw blades
Wear protective gloves!
Wear respiratory protection!
Wear protective glasses!
Wear hearing protection!
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries!
Genuine accessories/
auxiliary equipment
Only use the accessories and additional
equipment that are specifi ed in the operating in-
structions and are compatible with the appliance.
WARNING!
Protect yourself from laser radiation!
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
P max.: < 1 mW
λ: 650 nm
EN 60825-1: 2007
This appliance contains a Class 2 laser
and will be delivered with a laser
warning label
.
NEVER direct the laser beam at people or animals.
NEVER look directly into the laser beam. The
laser beam can cause serious eye damage.
Do NOT direct the laser beam at strongly
refl ective material. Refl ected laser beams are
also dangerous.
Any adjustment intended to increase the
intensity of the laser beam is forbidden.
There is a risk of personal injury!
No liability will be accepted for damage result-
ing from manipulation of the laser equipment or
from disregarding these safety instructions.
PHKSA 18-Li A1
CAUTION!
If operating and adjustment equipment is used or
procedures other than those specifi ed here are
carried out, this may result in hazardous radiation
exposure.

Before initial use

Charging the battery (see Fig. C)

CAUTION!
Always unplug the appliance before you
remove the battery pack
the battery pack to the charger
NOTE
Three appliances - three compatible batteries.
Interchangeable!
(see chapter ordering a replacement battery)
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
Connect the battery pack
charger
(see Fig. C).
Insert the mains plug into the mains power socket.
The red control LED
The green control LED
charging process is complete and the battery
pack
is ready.
Insert the battery pack
ance.
Never recharge a battery pack
immediately after rapid charging. This could
overcharge the battery pack
the lifespan of the battery and charger
Switch off the charger
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
Allow the battery pack
handle.
from or connect
.
when the
to the battery
lights up.
indicates that the
back into the appli-
again
, thus reducing
.
for at least 15 minutes
to click into the
21
GB

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis