Casualplay Baby 0+ SAFE TECH Anweisungen Seite 20

• Put the parking brake on.
• Place the Baby 0 SAFE TECH on the pushchair, facing backwards.
+
• Line the Unisystem fasteners on the Baby 0
• Press downwards until it clicks fastened and a green signal appears in each of the windows on the sides of
the fasteners (fig.21).
• To take the Baby 0
+
window) and pull upwards to release it from the pushchair chassis (fig.22).
Using the Baby 0 SAFE TECH as a rocker
+
• Place the Baby 0 SAFE TECH on the floor on a flat surface.
+
• Move the handle to the rocker position (consult the section about how to adjust the carrying handle). Make sure
that it clicks into position (fig.5) (C).
• The Baby 0 SAFE TECH will move as your baby moves.
+
• The baby should wear the harness fastened and should never be left alone.
WARNING: Never leave the child unsupervised.
Using the Baby 0 SAFE TECH as a seat
+
• Place the Baby 0 SAFE TECH on the floor on a flat surface.
+
• Move the handle to the stability position (consult the section about how to adjust the carrying handle). Make
sure that it clicks into position (fig.5) (A).
• The Baby 0 SAFE TECH can now be used as a seat for the baby.
+
Removing the upholstery
• Unfasten the safety harness and take the shoulder protector pads off.
• Turn the Baby 0 SAFE TECH round. Then undo the 4 fastening hooks found on the sides, and the plastic
+
strips.
• Lastly, pass the straps and the buckle through the slots in the upholstery.
• To fit the upholstery back onto the Baby 0
NOTE: It is very important that the protector pads are fitted back on. They are an important safety element and
must be used always.
Fitting the mosquito net (depending on the model)
• Unfold the hood. Undo the zip, found on the top part of the hood, and take the mosquito net out.
• Spread it out, fasten the elastic strip and the clips on the sides.
• To put the net away undo the side clips and the elastic strip. Roll it up and store it in the pocket.
Maintenance
• Clean the plastic parts with mild soap and warm water.
• Wash the upholstery and fabric parts by following the washing instructions indicated on the different fabric
care labels.
SAFE TECH off, press and then release the red button on both fasteners (red signal in the
SAFE TECH up with the slots (fig.20).
+
SAFE TECH follow the same steps in reverse order.
+