Silvercrest SPB 2600 C2 Bedienungsanleitung Seite 18

♦ The charging current of the connected device is
too low (< 80 mA) or too high (> 1 A).
♦ The internal overcurrent protection may have
been triggered. Disconnect the attached device
and connect the microUSB charging port
a power source for a short while (see section
Charging the Power Bank). Afterwards, the
Power Bank can be used again.
NOTE
► If you cannot solve the problem with the above-
mentioned solutions, please contact the Service
Hotline (see chapter entitled Service).
SPB 2600 C2
to
│
15
GB
■