Troubleshooting - Silvercrest SPB 2600 C2 Bedienungsanleitung

NOTE
► Alternatively, you can also use the original
charging cable (USB cable) provided by the
respective device manufacturer.
♦ During the charging process, the current charge
level of the Power Bank is shown via the charge
level LEDs
"Charging the Power Bank").
♦ To end the charging procedure, disconnect the
charging cable
the Power Bank. The charging status LEDs
off after about 30 seconds.

Troubleshooting

The Power Bank does not charge
♦ Connection may be faulty. Check the connection.
♦ Some computers deactivate the power supply to
the USB ports when they are switched off. Check
that the computer is switched on.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
process.
│
■ 14
(see table in chapter entitled
from the mobile device and
GB
to start the charging
SPB 2600 C2
go