Residual Risks; 4·3 Periodical Lubrication - Maggi STEFF 2032 Bedienungsanleitung

CHAPTER 4 • MAINTENANCE
4-1 NOTES
A
WARNING
ANY MAINTENANCE OR OTHER OP·
ERATION CONCERNING THE MA·
CHINE MUST BE CARRIED OUT A F·
TEA DISCONNECTING IT FROM THE
MAINS B Y REMOVING ITS PLUG
FROM THE ELECTRIC SOCKET.
This chapter details the most frequent
maintenance operations. For more
complex interventions refer to the ex-
ploded views in the following chapter
for the exact dismantling and reassem·
bling procedures and for the codes of
spare parts.
4-2 RESIDUAL RISKS
Despite all safety precautions there are
still some residual risks.
Residual risks are potential unapparent
dangers such as:
• Catching ones clothes or hair on
workpieces or while workpieces are
being conveyed.
- Being hit by parts or working resi-
dues cast outwards.
22
• Danger resulting from work on the
electrical system.
• Danger of getting jammed between
a workpiece being fed and the wall
( minimum distance between
workpiece and wall 500 mm).
If the Feed Unit is plugged into a
current tap that is not connected to
the controls of the woodworking
machine, there is a risk that the unit
will start suddenly when the power
is restored after an interruption of
current.
Danger of dragging between the
feed rollers and the workpiece.
4-3
PERIODICAL LUBRICATION
To keep the machine silent and in per-
fect working condition it is necessary
to:
1) Periodically injectATHESIA EP/21P
grease into the bearings through the
lubricators (T) shown in the figure
using the specially-designed pump
supplied in the outfit.
2) Periodically check the oil level in the
sump after unscrewing plug (D). The
oil level must never go lower than 4
em below the plug level. If neces-
sary, top up with OLEO BLITZ EHT
16 or other oil with viscosity SAE 30.
3) Lubricate the slides of the support.