Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CHAPTER
2 ·
INSTALLATION
This chapter contains all the
instruc-
tions
required to
correctly assemble the
machine.
2·1 ASSEMBLING THE SUP·
PORT
1) Insert horizontal racked
tube
(A).
2)
Fit
articulated collared group (B) to
the
end of tube (C) and tighten
clamping screw (D).
3) The
support
is adjusted
with
the
handwheel (E).
16
2 ·2 PLACING AND
FASTENING
THE SUPPORT ON THE
WORKSTAND
Before carrying out the fastening, it
is
advisable
to consider the dimensions
of the machine when assembled, as
shown
in
the figure on page 17. One
should consider
the
space
required
for
working, which depends on the way the
Feed unit will
be
used, so as to find the
best position for the support base. Page
18 and
the
following illustrate the dif-
ferent
uses
and
provide
a few exam-
ples of optimum positioning of the
Feed
unit.
As to the distance between
the
holes
in the
workstand,
refer
to
the
figure
on
this page.
It
is
necessary to bore
four
14-mm
clearance holes
through the machine
bench.
For the fastening, use
M12
bolts with matching washers and nuts.
Calculate the
lenght
of the bolts so that
they
can come out from
the
machine
bench for a greater
length
than that
one of the washers with the nuts.
Should it not be
possible
to bore
clear-
ance holes, drill four blind holes
with
a
10.2
bit and
thread with
an
M12
tap to
a
depth
of at least 35 mm. Then fasten
with M12 bolts 50·55 mm
in
length.
Werbung
Kapitel
Inhaltsverzeichnis
