Adjusting The Transmission; Adjusting The Self-Propel Cable - Toro TurfMaster 22205TE Bedienungsanleitung

Adjusting the Transmission

If the machine starts to lose traction, check and adjust
the transmission.
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug.
3. Loosen the bolt and nut holding the bracket into
place.
4. Adjust the bracket so that it is in contact with the
transmission.
Note:
The bracket prevents the transmission
from tipping to the point where the transmission
belt comes off.
5. Tighten the bolt and nut to secure the bracket
into place.
Adjusting the Self-Propel
Cable
If the machine does not self-propel or tends to creep
forward when you release the control bar, adjust the
drive cable.
1. Stop the machine and wait for all moving parts
to stop.
2. Loosen the cable-support nut
1. Cable-support nut
3. Slide the cable-support nut toward the machine
to increase the self-propel action; slide the
cable-support nut away from the machine to
decrease the self-propel action.
4. Tighten the cable-support nut.
5. Check the operation for the desired drive control,
and repeat the steps above, if necessary.
Note:
If the machine creeps forward without the
control bar engaged or if the wheels spin when
you lift the rear wheels off the ground, the cable
is too tight; loosen the cable-support nut, pull the
cable jacket upward (away from the machine)
slightly, and tighten the cable-support nut.
Note:
You may also adjust the maximum
ground speed (when the control bar is fully
engaged) as desired.
28
(Figure 50).
Figure 50
g019876