Checking The Engine Oil Level; Adjusting The Cutting Height - Toro Emotion 43 Bedienungsanleitung

Checking the Engine Oil Level

Service Interval: Before each use or daily
1. Remove the dipstick, wipe it clean, and fully install
the dipstick (Figure 8).
2. Remove the dipstick and check the oil level
(Figure 8). If the oil level is below the Add mark on
the dipstick, slowly pour oil into the oil fill tube to
raise the oil level to the Full mark on the dipstick.
Do not overfill. (Max. fill: 0.59 l, type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick.

Adjusting the Cutting Height

You can adjust the mower to cut grass at any height
from 2.2 cm to 7.6 cm.
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing
when adjusting the cutting height.
If the engine has been running, the muffler will
be hot and can severely burn you. Keep away
from the hot muffler.
• Cut the grass at the C, D, or E settings. Do not
attempt to recycle the grass at the A or B
settings.
• Do not cut below the C setting unless the grass is
sparse or it is late fall when grass growth begins to
slow down. When you cut long grass, use a higher
cutting height setting and walk slower; then cut the
grass again at a normal setting. Mowing the grass
when it is too long can plug the lawn mower and
cause the engine to stall.
Note: The SmartWheel
to ensure that you cut no more than a third of the grass
blade (Figure 11).
® calculates the proper setting
1. Cutting height adjustment
handle
2. Cutting height adjustment
button
3. Cutting height scale
1. Stop the engine and wait for all moving parts to stop.
2. Move the mower into the grass; stop moving the
mower when the SmartWheel design is upright
(Figure 11).
3. Use the SmartWheel design to compare the tips of
the grass blades to the letters on the wheel. The
letter on the SmartWheel that matches the tips of the
grass blades is the proper cutting height.
4. Press down on the cutting height adjustment button
and hold the cutting height adjustment handle to
move the cutting height up or down (Figure 11).
5. Lift up or press down on the handle, and use the
cutting height scale to set the lawn mower to the
desired cutting height (Figure 11).
8
Figure 11
4. Raise or lower the mower
5. Smart Wheel