Adjusting The Handle Height; Adjusting The Cutting Height - Toro 48cm 60V Super Recycler Bedienungsanleitung

Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3
positions, and lock the handle into position
10).
Figure 10
1. Handle lock
(Figure
g007284
2. Handle positions
Adjusting the Cutting
Height
WARNING
Adjusting the cutting-height levers could
bring your hands into contact with a moving
blade and result in serious injury.
• Shut off the machine and wait for all
moving parts to stop before adjusting the
cutting height.
• Do not put your fingers under the housing
when adjusting the cutting height.
Adjust the cutting height as desired. Set all the
cutting-height levers to the same height. To raise and
lower the machine, refer to
1. Cutting-height lever
Important:
The cutting height settings are 25 mm
(1 inch); 38 mm (1-1/2 inch); 51 mm (2 inches); 64
mm (2-1/2 inches); 83 mm (3-1/4 inches); 95 mm
(3-3/4 inches); 108 mm (4-1/4 inches).
13
Figure 11.
Figure 11
g012130