Changing The Engine Oil - Toro TurfMaster 22205TE Bedienungsanleitung

Figure 27
1. Cover
2. Foam pre-filter and paper
filter
4. Remove the foam pre-filter from the paper filter
(Figure 27), and replace the paper filter if it is
excessively dirty.
Important:
Do not try to clean a paper filter.
5. Wash the foam pre-cleaner with a mild detergent
and water, then blot it dry.
Note:
Do not add oil to the foam pre-cleaner.
6. Install the foam pre-cleaner onto the paper filter.
7. Install the air-filter assembly.
8. Install the cover.
g006591
3. Air-filter base

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the
engine oil without the oil filter.
Every 50 hours—Change the engine oil (more
often in dusty conditions).
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Refer to Maintenance Safety (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
4. Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (Figure 29).
18
0.65 L (22 fl oz) without oil
filter; 0.85 L (29 fl oz) with oil
filter
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
17).
(Figure
Figure 28
3. Low
28).
g194742