Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro TurfMaster 22205TE Bedienungsanleitung

Important:
To reduce starting problems, add
fuel stabilizer to the gasoline all season. Mix the
stabilizer with gasoline less than 30 days old.
Note:
The capacity of the fuel tank is 1.8 L (0.47
US gallon).
Checking the Engine-Oil
Level
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
Figure 13
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low
(Figure 13), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps 3 through
is at the correct level. For the oil type, refer
to Changing the Engine Oil (page
•
If the oil level on the dipstick is too high
(Figure 13), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6. Install the dipstick into the oil-fill tube securely.
(Figure
3. Low
(Figure 13).
5 until the oil on the dipstick
18).
18).
Adjusting the Cutting
Height
The cutting heights range from 38 mm (1-1/2 inches)
to 127 mm (5 inches) in 13 mm (1/2 inch) increments.
13).
View from front, left side of the machine
1. 38 mm (1-1/2 inches)
2. 51 mm (2 inches)
3. 64 mm (2-1/2 inches)
4. 76 mm (3 inches)
You control the cutting height with a front lever and
g194742
a rear lever; both levers are on the left side of the
machine (Figure 15
the machine, disengage the lever, raise or lower the
machine, and then engage the lever by releasing it.
1. Squeeze the lever to disengage it.
10
Figure 14
5. 89 mm (3-1/2 inches)
6. 102 mm (4 inches)
7. 114 mm (4-1/2 inches)
8. 127 mm (5 inches)
and Figure 16). To raise or lower
Figure 15
Front Cutting-Height Lever
g019911
g019653