Adjusting The Cutting Height - Toro Flex-Force Power System 60V MAX 36 cm Bedienungsanleitung

Adjusting the Cutting
Height
WARNING
Adjusting the height-of-cut could bring your
hands into contact with a moving blade and
result in serious injury.
• Shut off the motor, remove the battery, and
wait for all moving parts to stop before

adjusting the cutting height.

• Do not put your fingers under the housing
when adjusting the cutting height.
To adjust the cutting height, press down on the
height-of-cut button and raise or lower the deck until
the desired height-of-cut setting is shown in the
height-of-cut window (Figure
1. Height-of-cut button
9).
Figure 9
2. Height-of-cut view window
The height of cut is adjustable in 6 increments
between 19 mm (3/4 inch) and 70 mm (2-3/4 inches).
Indicator
g364065
12
Height of Cut Position
1 (lowest)
2
3
4
5
6 (highest)