Installation Instructions - wiking Miro 1 Installations- Und Bedienungsanleitung

Installation Instructions

Before You Start (Figure A)
Figure A is a cross-sectional view of your wood-burning stove . Here you can gain an overview of
the parts of which your stove consists .
1. Steel smoke deflector.
2. Vermiculite smoke deflector.
3 . Vermiculite rear plate .
4 . Vermiculite corner plate .
5 . Vermiculite side plate .
Please note: The combustion chamber is covered with plates made of vermiculite, which is a
heat-insulating material . These plates ensure that the optimal combustion temperature is quickly
reached, and they must therefore remain inside in the wood-burning stove .
The steel smoke deflector and the vermiculite smoke deflector ensure that the passage of
smoke through the stove is as long as possible, so that the flue gasses have more time to emit
their warmth within the stove and the surrounding area . In this way you get more warmth from
the wood you add to the stove, as the warm smoke is not simply sent out through the chimney .
Arrangement of Individual Components (Figure A)
It is important to ensure that all individual components are in place and no damage was done
to them during transport . In Figure A you can see the parts that you must inspect:
1 . The steel baffle plate (1) is hung from two hooks and equipped with two pins (7) that serve
as protection during transportation . Remember to remove the two pins before you start
using the stove .
2 . The vermiculite smoke deflector (2) plate must rest on the two fittings (8) at the top and front
of the combustion chamber and must be pushed as far back as possible into the combustion
chamber .
3 . The rear plate (3) must be pushed all the way back in the combustion chamber .
4 . The cast iron bottom plate (6) should lie flat in the bottom of the combustion chamber.
Only when you are confident that the individual components are in place, you may begin with
the installation of the wood-burning stove .
The cover plate
Your WIKING wood-burning stove comes with a separate cover plate that should be placed
on top of the grate in the bottom of the combustion chamber . It is recommended that the cover
plate is always used, since it prevents the embers from falling into the ash pan . Hence the cover
plate is important for the build-up of a good layer of embers, on top of which you can place the
firewood. The cover plate is designed in such a way that the automatically controlled air supply
is distributed equally across the bottom of the combustion chamber .
Changing the Smoke Outlet from Top Outlet to Rear Outlet
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
1 . Lift the top plate off the stove .
2 . Remove the smoke ring on the top of the stove by unscrewing the three screws and lifting it off .
3. There is a cut-out for the flue duct in the back plate. Break off the plate within this cut-out to
make a hole that the flue duct can fit into.
22