Lighting And Firing Your Wiking Wood-Burning Stove - wiking Miro 1 Installations- Und Bedienungsanleitung

Achieving the Best Possible Combustion
Use Dry, Clean Wood
Wet wood results in poor combustion, excess smoke and soot . In addition, more warmth will
be used to dry the wood instead of heating the room .
Fire a Bit at a Time
You achieve the best possible combustion by firing often and a bit at a time. If you add too
much firewood at once, too much time will pass before the temperature becomes high enough
for you to achieve good combustion .
Make Sure there is the right Amount of Air in the Combustion Chamber
You should also make sure that there is an ample amount of air - especially in the beginning - so
that the temperature inside the wood-burning stove quickly rises . Gases and particles released
during burning are then more easily burned off . Otherwise, they gather as soot in the chimney
(which increases the risk of chimney fire) or are emitted unburned into the atmosphere. The
wrong amount of air supply creates inefficient combustion and a modest effect.
Don't Savour the Fire during Night Time
We advise against adding fire wood to your stove and reducing the air supply at night in an at-
tempt to still have some embers left in the morning . If you do so, large amounts of hazardous
smoke will be emitted, and your chimney will be exposed to unnecessarily large amounts of
soot with the risk of a chimney fire.

Lighting and Firing your WIKING Wood-Burning Stove

The First Firing
The first time you fire your wood-burning stove, you must do so carefully, as all materials
need to adjust to the heat . This means that the stove must be heated slowly, until it reaches
its maximum heat level. Afterwards, you should fire a few times so that the stove is thoroughly
heated throughout .
Be Careful of the Lacquer
The lacquer used to treat the wood-burning stove will harden the first 2-3 times the stove is
fired, and this can create unpleasant smoke and odours. Ensure therefore that the room is well
ventilated . The door must also be carefully opened; otherwise there is a risk that the seals will
stick to the lacquer .
Warning: The enclosed gloves can scratch the surface paint if the lacquer has not hardened
properly. Be careful not to touch the lacquered surfaces until after the first 2-3 firings.
27