Herunterladen Inhalt Inhalt Diese Seite drucken

Installation Instructions; Before You Start - wiking Atomic Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Installation Instructions

Before You Start

Figure  is a cross-sectional view of your wood-burning stove. Here
you can gain an overview of the parts of which your stove consists.
Steel smoke deflector. Cannot be removed.
.
Vermiculite smoke deflector.
2.
3.
Air intake on the rear plate.
4.
Vermiculite rear plate.
5.
Vermiculite base plates.
6.
Grate.
7.
Log trap.
8.
Air-regulation damper.
Please note: The combustion chamber is covered with plates made of vermiculite, which is
a heat-insulating material. These plates ensure that the optimal combustion temperature is
quickly reached, and they must therefore remain inside in the wood-burning stove.
The permanent steel smoke deflector and the loose vermiculite smoke deflector ensure that
the passage of smoke through the stove is as long as possible, so that the flue gasses have
more time to emit their warmth within the stove and the surrounding area. In this way you get
more warmth from the wood you add to the stove, as the warm smoke is not simply sent out
through the chimney.
Arrangement of Individual Components
It is important to ensure that all individual components are in place and no damage was done
to them during transport. In Figure  you can see where the parts should be located in the
stove. The individual components that you must inspect are:
The vermiculite smoke deflector should rest on the side plates and be pushed all the way
.
back in the combustion chamber.
2.
The rear plate must be pushed all the way back in the combustion chamber.
The base plates must lie flat on bottom around the grate.
3.
Only when you are confident that the individual components are in place, you may begin with
the installation of the wood-burning stove.
Preparing the Wood-burning Stove for Use
Before using your wood-burning stove, remove the cardboard pieces used to keep the vermi-
culite plates and ash pan in place inside the combustion chamber during transport. From the
ash pan, remove the user handle, log trap and pipe used for fresh air intake.
Remove the plastic from the log trap and place it in the holders in the front of the combustion
chamber (see figure 1, section 7).
English
1
2
3
4
6
7
5
8
Fig. 1
2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis