wiking Miro 1 Installations- Und Bedienungsanleitung Seite 23

4 . Remove the cover plate on the back of the stove by unscrewing the three screws (Torx Bit
no . 30) and lifting it off .
5 . Install the cover plate on top of the stove with the three screws .
6 . Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws .
7 . Replace the top plate on the stove .
A top cover can be bought as an accessory to cover the hole in the top plate of the stove if the
stove is connected to a rear smoke outlet .
The adjustable feet (Figure B)
WIKING Miro 3/Miro 4 has four adjustable feet built into the bottom plate . Open the door under
the wood section . Loosen the screws in each side of the vertical cover plate in the back of the
chamber by using an Allen key . Lift up the cover plate, tilt the lower part forward and pull the
cover plate out . Adjust the adjustable screws, two in each side, to get the desired height, using
the Allen key . Hook the cover plate back in place and tighten the two screws .
The adjustable feet of WIKING Miro 1/Miro 2 stand on the plinth, which is delivered along with
the wood-burning stove . First you mount the stove on the plinth (see separate instructions) . Tilt
the stove backwards and adjust the screws to get the desired position .
General Information
When installing your WIKING wood-burning stove, you must ensure that all local regulations,
including those referring to national and European standards, are observed . It is always a good
idea to consult a chimney sweep before installing your stove, as it is he/she who must ultimately
approve the installation . Always follow the instructions of the manual carefully and make sure
that the installation is carried out by a qualified professional. WIKING packaging material should
always be handled in accordance with the local rules for waste handling .
Room Requirements
It must always be possible to deliver fresh combustion air to the room in which the wood-burning
stove is to be installed . A window that can be opened or an adjustable air valve is considered
to be sufficient. The adjustable air valve/air grate must not be blocked.
Technical Data
If the wood-burning stove is to be placed on a floor made of combustible material, the area
around the stove must be covered with a non-combustible material. The floor construction must
also be able to withstand the weight of the stove and the chimney . The chimney's weight must
be calculated in relation to dimension and height .
In the table below you'll find important information about your wood-burning stove.
Wood-burning stove's weight
The wood-burning stove's
dimen-sions (H x W x D)
Distance to furniture - in front of
the wood-burning stove
WIKING Miro 1 / Miro 2
83 kg / 81 kg
70 .8 x 46 .8 x 35 .6 cm
100 cm
WIKING Miro 3 / Miro 4
94 kg / 92 kg
100 .8 x 46 .8 x 35 .6 cm
100 cm
23