Safety Instruction; General Recommendations - IKEA FÖRDELAKTIG Bedienungsanleitung

ENGLISH

Safety instruction

General recommendations

• Never use scouring pads, steel wool,
muriatic acid or other products which
could scratch or mark the surface.
• Foods that accidentally fall or settle
on the surface, on the functional or
aesthetic elements of the hob must
not be eaten.
Cabinet requirements
• The cooking hob is intended to be
built into the worktop above a kitchen
cabinet of 800 mm width or more.
• If fitting in flammable material, the
guidelines and standards for low
voltage installations and for the fire
protection must be strictly observed.
• For fitted units, the components
(plastic materials and veneered
wood) must be assembled with
heat-resistant adhesives (min.
85°C): Unsuitable materials and
adhesives can result in warping and
detachment.
• The kitchen cabinet must allow
sufficient room for the electrical
connections of the appliance.
Suspended kitchen cabinets above
the appliance must be installed at a
distance that provides enough room
for comfortable working process.
• The use of hard wood decorative
borders around the worktop behind
the appliance is allowed, in this
case the minimum distance remains
as indicated on the installation
illustrations.
• The minimum distance between the
built-in appliance and rear wall is
indicated at the illustration for the
installation of the built-in appliance
(75 mm for the rear and 500 mm
minimum for any cabinets above it).
490
• To prevent leakage of liquid between
the edge of the hob and the
countertop, place the adhesive seal
provided along the entire outer edge
of the hob before assembly.
Electrical connection
• The wire connection has to be done
by specialized technician.
• This appliance has a Type "Y"
attachment and requires at least a
power supply cord Type H05VV-F.
MONO-PHASE, BI-PHASE and THREE-
PHASE connection: min. section of
the conductors: 2,5 mm². External
diameter of the supply cord: min. 7
mm - max. 15 mm.
• Connection terminals are revealed
when the connection box cover is
removed.
• Make sure the characteristics of the
household electrical system (voltage,
maximum power and current)
are compatible with those of the
appliance.
• Connect the appliance like shown in
the diagram (in accordance with the
mains voltage and country standard
reference).
• We suggest to use power supply cord
5 x 2.5 mm² H05V2V2-F, included in
the package. In case of use of power
supply cord 5 x 2,5 mm² H05V2V2-F,
below instructions have to be
followed: for three-phase connection
75
separate the 2 wires crimped together
and remove the light blue sheaths
from grey wires.
Min. 500 mm
9