Safety Instruction - IKEA TILLREDA AA-2398328-1 Bedienungsanleitung

ENGLISH

Safety instruction

Installation
• Manufacturer is not responsible for any injury to
persons and pets or damage to property caused by
failure to comply following requirements.
Caution! To proceed with the installation refer
to the Safety Information.
Warning! Installation process must follow the
laws, ordinances, directives and standards
(electrical safety rules and regulations, proper
recycling in accordance with the regulations,
etc.) in force in the country of use!
• Avoid installing the appliance next to doors and
under windows as hot cookware may be knocked
off the hob when doors and windows are opened.
• Make sure that the appliance is not damaged
because of transport. Do not connect a damaged
appliance.
• Do not install the appliance if it is damaged during
the transportation.
• Do not connect the hob with extension cords and do
not place the hob with cord across working areas.
• Do not change the specifications or modify
this product. Risk of injury and damage to the
appliance.
Warning! Carefully obey the instructions for
electrical connections.
Electrical connections
• Before connecting, check that the nominal
voltage of the appliance stated on the rating
plate, corresponds to the available supply voltage.
Also, check the power rating of the appliance and
ensure that the home's electrical installation is
suitably sized to suit the appliance power rating
(refer to the Technical data chapter).
• The rating plate is located on the lower casing of
the hob.
Warning! Risk of injury from electrical current.
• Loose and inappropriate plug and socket
connections can make the terminal overheat.
Before Use:
Please pay attention to the following instructions
before use.
• Please use the standard main power supply socket,
and regularly check the socket to prevent any
damage.
• Do not open the appliance by yourself or any
unqualified person. Only repair the appliance by its
service agent or similarly qualified technician.
• Please check with the power cord and plug. If the
power cord or plug is damaged, please do not use
the appliance. Do not pull out the plug with wet
hand.
• Do not use the extension power cord, and please
use the main power supply socket only.
• If the appliance is not in use for a long period of
time, please turn on the appliance to stabilize the
electronic component for 10 minutes first. Then,
you can start to operate the appliance.
• Do not use the appliance near water, fire or damp
area. The appliance is intended to use in indoor
household ONLY.
• Remove all packaging, stickers and film remove the
appliance before the first use.
• Switch the cooking zones off after each use by its
controls and do not rely on pan detector.
• Risk of burns! Do not place objects made of metal,
such as knives, forks, spoons and saucepan lids on
the cooking surface, as they can get hot.
Warning! Fire hazard! Overheated fats and oils
can ignite very quickly.
Warning! Users with implanted pacemakers
should keep their upper body at least 30 cm
from induction cooking zones that are switched
on.
Warning! Do not operate the appliance with
wet hands and keep control panel surface dry.
Lot of water on control panel keys will make
them no longer operable.
During & After use:
Please pay attention to the following instruction to
prevent ignition and accidents.
• Please place the appliance on flat and solid surface
ONLY.
• Children should be supervised to ensure that they
do not play with the appliance.
• Do not place any following objects on the panel
when the appliance is operating.
a) Stainless steel
b) Iron
c) Cast iron
d) Aluminum
e) Lid and enamel
f) Knife, folk or spoon
g) Plate made of iron, stainless steel, cast iron or
aluminum
h) Empty cookware
• Do not carry or move the appliance with cookware
on top during heating.
• Please maintain a good surrounding environment
for ventilation during heating.
• Do not insert any wire or metal objects into the air
inlet or air outlet of the appliance.
• How to take care of the panel
a) Do not drop any heavy objects to the panel.
b) Do not pour water, acid or any liquid to the panel.
c) Do not burn anything with fire on the panel.
7