hilscher DTM Bedienungsanleitung Seite 131

Fehlercodes
CIP Connection-Manager-Object-Instance Codes zum Erweiterten Status
Allgemeiner Erweiterter
Status (hexa Status
dezimal)
0x01 0x0306
0x01 0x0307
through
0x0310
0x01 0x0311
0x01 0x0312
0x01 0x0313
through
0x0314
0x01 0x0315
0x01 0x0316
0x01 0x0317
0x01 0x0318
0x01 0x0319
0x01 0x031A
0x01 0x031B
0x01 0x031C
DTM für EtherNet/IP-Scanner-Geräte | Konfiguration von EtherNet/IP-Scanner-Geräten
DOC061201OI07DE | Revision 7 | Deutsch | 2013-09 | Freigegeben | Öffentlich
Beschreibung
SCHEDULE SIGNATURE VALIDATION NOT POSSIBLE
This extended status code shall be returned when the connection scheduling
information in the originator device can not be validated on the target network. For
example, on ControlNet this code shall be returned when there is no keeper in the
master state.
Reserved by CIP
PORT NOT AVAILABLE
A Port specified in a Port Segment is Not Available or does not exist.
LINK ADDRESS NOT VALID
Link Address specified in Port Segment Not Valid
This extended status code is the result of a port segment that specifies a link
address that is not valid for the target network type. This extended status code
shall not he used for link addresses that are valid for the target network type but
do not respond.
Reserved by CIP
INVALID SEGMENT IN CONNECTION PATH
Invalid Segment Type or Segment Value in Connection Path
This extended status code is the result of a device being unable to decode the
connection path. This could be caused by an unrecognized path type, a segment
type occurring unexpectedly, or a myriad of other problems in the connection path.
FORWARD CLOSE SERVICE CONNECTION PATH MISMATCH
The connection path in the Forward_Close Service does not match the connection
path in the connection being closed.
SCHEDULING NOT SPECIFIED
Either the Schedule Network Segment was not present or the Encoded Value in
the Schedule Network Segment is invalid (0).
LNK ADDRESS TO SELF INVALILD
Under some conditions (depends on the device), a link address in the Port
Segment which points to the same device (loopback to yourself) is invalid.
SECONDARY RESOURCES UNAVAILABLE
In a dual chassis redundant system, a connection request that is made to the
primary system shall be duplicated on the secondary system. If the secondary
system is unable to duplicate the connection request, then this extended status
code shall be returned.
RACK CONNECTION ALREADY ESTABLISHED
A request for a module connection has been refused because part of the
corresponding data is already included in a rack connection.
MODULE CONNECTION ALREADY ESTABLISHED
A request for a rack connection has been refused because part of the
corresponding data is already included in a module connection.
MISCELLANEOUS
This extended status is returned when no other extended status code applies for a
connection related error.
131/154
© Hilscher, 2006-2013