hilscher DTM Bedienungsanleitung Seite 130

Fehlercodes
CIP Connection-Manager-Object-Instance Codes zum Erweiterten Status
Allgemeiner Erweiterter
Status (hexa Status
dezimal)
0x011B
0x01
through
0x0202
0x01 0x0203
0x01 0x0204
0x01 0x0205
0x01 0x0206
0x01 0x0207
0x01 0x0208
through
0x0300
0x01 0x0301
0x01 0x0302
0x01 0x0303
0x01 0x0304
0x01 0x0305
DTM für EtherNet/IP-Scanner-Geräte | Konfiguration von EtherNet/IP-Scanner-Geräten
DOC061201OI07DE | Revision 7 | Deutsch | 2013-09 | Freigegeben | Öffentlich
Beschreibung
Reserved by CIP
CONNECTION TIMED OUT
This extended status code shall occur when a client tries to send a connected
message over a connection that has been timed-out, This extended status code
shall only occur locally at the producing node.
UNCONNECTED REQUEST TIMED OUT
The Unconnected Request Timed Out error shall occur when the UCMM times out
before a reply is received. This may occur for an Unconnceted_Send,
Forward_Open, or Forward_Close service. This typically means that the UCMM
has tried a link specific number of times using a link specific retry timer and has
not received an acknowledgement or reply. This may be the result of congestion
at the destination node or may be the result of a node not being powered up or
present. This extended status code shall be returned by the originating node or
any intermediate node.
PARAMETER ERROR IN UNCONNECTED REQUEST SERVICE
For example, this shall be caused by a Connection Tick Time (see section 3-
5.5.1.3) and Connection time-out combination in an Unconnected_Send,
Forward_Open, or Forward_Close service that is not supported by an
intermediate node.
MESSAGE TOO LARGE FOR UNCONNECTED_SEND SERVICE
This shall be caused when the Unconnected_Send is too large to be sent out on a
network.
UNCONNECTED ACKNOWLEDGE WITHOUT REPLY
The message was sent via the unconnected message service and an
acknowledge was received but a data response message was not received.
Reserved by CIP
NO BUFFER MEMORY AVAILABLE
The extended status code shall occur when insufficient connection buffer memory
is available in the target or any router devices. Routers and target nodes shall
return this error.
NETWORK BANDWIDTH NOT AVAILABLE FOR DATA
This extended status code shall be returned by any device in the path that is a
producer and can not allocate sufficient bandwidth for the connection on its link,
This can occur at any node. This can only occur for connections that are specified
a scheduled priority
NO CONSUMED CONNECTION ID FILTER AVAILABLE
Any device in the path that contains a link consumer for the connection and does
not have an available consumed_connection_id filter available shall return this
extended status code.
NOT CONFIGURED TO SEND SCHEDULED PRIORITY DATA
If requested to make a connection that specifies scheduled priority, any device
that is unable to send packets during the scheduled portion of the network update
time interval shall return this extended status code. For example, on ControlNet
this code shall be returned by a node whose MAC is greater than maximum
scheduled node (SMAX).
SCHEDULE SIGNATURE MISMATCH
This extended status code shall be returned when the connection scheduling
information in the originator device is not consistent with the connection
scheduling information on the target network.
130/154
© Hilscher, 2006-2013