hilscher DTM Bedienungsanleitung Seite 124

Fehlercodes
Status- & Fehlercodes TCP_IP
Fehlercode (Definition)
TLR_E_TCP_ERR_DEST_
UNREACHABLE_TCP_CMD_ CONNECT
TLR_E_TCP_ERR_DEST_
UNREACHABLE_UDP_CMD_ SEND
TLR_E_IP_ERR_TIMEOUT_ IP_CMD_PING
TLR_E_TCP_ERR_TIMEOUT_
TCP_UDP_CMD_CLOSE
TLR_E_TCP_ERR_TIMEOUT_
TCP_UDP_CMD_CLOSE_ALL
TLR_E_TCP_ERR_TIMEOUT_
TCP_CMD_WAIT_CONNECT
TLR_E_TCP_ERR_TIMEOUT_
TCP_CMD_CONNECT
TLR_E_TCP_ERR_TIMEOUT_ TCP_CMD_SEND
DTM für EtherNet/IP-Scanner-Geräte | Konfiguration von EtherNet/IP-Scanner-Geräten
DOC061201OI07DE | Revision 7 | Deutsch | 2013-09 | Freigegeben | Öffentlich
Tabelle 63: Status- & Fehlercodes TCP_IP-Task
Wert Beschreibung
0xC0080304 Command
TCPIP_TCP_CMD_CONNECT_REQ: The
destination (host, network, or port) is
unreachable.
0xC0080305 Command
TCPIP_UDP_CMD_SEND_REQ: The
destination (host, network, or port) is
unreachable.
The specified timeout ulTimeout in
0xC0070310
command TCPIP_IP_CMD_PING_REQ
has expired. The specified host is not
reachable.
0xC0080311 The TCP Close timeout has expired. A
connection to the remote host could not be
closed gracefully within this time. For this
timeout, see command
TCPIP_TCP_UDP_CMD_CLOSE_REQ,
parameter ulTimeout.
0xC0080312 The TCP Close timeout has expired. One
or more connections to remote host(s)
could not be closed gracefully within this
time. For this timeout, see command
TCPIP_TCP_UDP_CMD_CLOSE_
ALL_REQ, parameter ulTimeout.
0xC0080313 The TCP Connect timeout has expired. No
remote host has connected within this
time. For this timeout, see command
TCPIP_TCP_CMD_WAIT_CONNECT_
REQ, parameter ulTimeoutListen.
The TCP Connect timeout has expired. A
0xC0080314
connection to the specified remote host
could not be established within this time.
For this timeout, see command
TCPIP_TCP_CMD_CONNECT_REQ,
parameter ulTimeoutConnect.
0xC0080315 The TCP Send timeout has expired by
sending TCP data with command
TCPIP_TCP_CMD_SEND_REQ. The
remote host has not answered within the
Send Timeout. The TCP Send timeout is
set in command TCPIP_TCP_CMD_
WAIT_CONNECT_REQ or
TCPIP_TCP_CMD_CONNECT_REQ,
parameter ulTimeoutSend (Default = 31 s).
124/154
© Hilscher, 2006-2013