Replacing Wheels; Replacing A Fuse - Stiga MP 84C Gebrauchsanweisung

If this is not sufficient to achieve an even cut,
please contact your Dealer who will test and
make the necessary adjustments to the align-
ment of the cutting deck.

6.3.2 Replacing wheels

Stop the machine on flat ground and put a block
under a load-bearing part of the frame on the
side that the wheel is to be changed.
The wheels
are held by a
snap ring (1)
which can be
eased off with a
screwdriver.
NOTE
one or both rear wheels, make sure that any
differences in their external diameter does not
exceed 8-10 mm; on the contrary, to prevent an
uneven cut it will be necessary to adjust the
alignment of the cutting deck.
IMPORTANT
wheel, apply grease to the axle. Put the snap
ring (1) and supporting washer (2) back in
place.
6.3.3 Replacing and repairing the tyres
The tyres are «Tubeless» and so all punctures
must be repaired by a tyre repairer following the
procedures required for this kind of tyre.
EN 24
2 1
If you have to replace
Before remounting the
6.3.4 Replacing the bulbs (if present)
• Type "I" bulbs (incandescent)
The bulbs (18W) have a bayonet fitting and are
installed in the bulb holder which can be taken
out by turning it anti-clockwise with pliers.
• Type "II" bulbs (LED)
Unscrew the ring-nut (1) and remove the connec-
tor (2).
Remove the LED illuminator (3), secured by
screws (4).

6.3.5 Replacing a fuse

The machine is fitted with fuses (1) with different
capacities and functions. Specifically:
– 10 A fuse = protects the main and power cir-
cuits of the electronic board. When it blows, the
machine stops.
1
4 3
1 2
4
1