Safety Instructions For Maintenance And Care - ergoline ESPRIT 770 Dynamic Power Gebrauchsanweisung

Safety instructions for maintenance and care

Danger to life!
Disconnect the sunbed from the power supply when performing
maintenance work requiring opening of the device.
See page 156.
Maintenance and care play a major role in deciding whether your sunbed
meets your requirements satisfactorily. Compliance with the specified
maintenance intervals and thorough maintenance and care are therefore
absolutely essential.
You can call up the current operating hours of the parts to be serviced in
preset mode.
Refit any protective devices (e.g. filter panels) after finishing working on
the sunbed.
Please note that the device must be inspected regularly by our customer
service or an approved specialised company every 12 months (from date
of commissioning) to maintain its proper condition.
Risk of burning!
When changing the UV low pressure lamps, the enclosed chip
card must always be used! The UV low pressure lamps can
only be operated at the correct power if the lamp set and chip
card are exchanged simultaneously.
If the old chip card is left in the unit, the new lamp set is oper-
ated at too high power and the user may suffer heavy burns!
154
Danger of burns!
Only use the specified genuine low pressure UV lamps and
filter panels! (see "Installed lamps" on page 206 and see
"Notes on installed lamps and tanning times" on page 106).
Using other low pressure UV lamps leads to modified radia-
tion. This could potentially result in severe burns to the user!
The use of other low pressure UV lamps and filter panels in-
validates CE conformity and the GS approval mark!
Caution!
Use only genuine spare parts of the same type! The use of
other parts voids the CE conformity!
Any liability is excluded in the case of damage or injury proven
to be the result of the use of non-genuine spare parts.