Pioneer KRP-600A Bedienungsanleitung Seite 70

12 Using with other equipment
When using the INPUT 4 HDMI terminal:
INPUT 2
LAN (10 / 100) DIGITAL OUT
OPTICAL
Media Receiver (rear)
Activating the HDMI terminal
When you use the INPUT 1 or INPUT 3 HDMI terminal, select the
terminal for the desired input source, then perform the following
procedure to activate the terminal.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "Option" (/ then ENTER).
4 Select "HDMI Input" (/ then ENTER).
5 Select "Setting" (/ then ENTER).
6 Select "Enable" (/ then ENTER).
Item Description
Disable (default) Deactivates the HDMI terminal
Enable Activates the HDMI terminal
7 Press HOME MENU to exit the menu.
Specifying the type of input signals
1 Repeat steps 1 to 4 provided for Activating the HDMI terminal.
2 Select "Signal Type" (/ then ENTER).
3 Select "Video" or "PC" (/ then ENTER).
Item Description
Select this option except when a PC is
Video (default)
connected
PC Select this option when a PC is connected to
the HDMI input terminal
70
En
Y P B P R
L
COMPONENT VIDEO
R
AUDIO R L
INPUT 2 SUB WOOFER OUT AUDIO OUT SERVICE ONLY
CONTROL SYSTEM
CABLE
OUT
HDMI HDMI HDMI HDMI
INPUT 1 INPUT 3 INPUT 4
HDMI compliant cable
(HDMI cable having the
HDMI mark)
HDMI device
4 Press HOME MENU to exit the menu.
Caution
• Make sure to select "PC" when a PC is connected to the HDMI
input terminal.
Note
• In the "Video" mode, the image is "over-scanned" (enlarged),
and the mode is automatically switched to "PC" when PC
signals are received.
• In the "PC" mode, the image is displayed in full size for optimum
image quality.
when "Video" is selected
("overscan" size screen)
Specifying the type of digital video signals
1 Repeat steps 1 to 4 provided for Activating the HDMI terminal.
2 Select "Video" (/ then ENTER).
3 Select the type of digital video signals (/ then ENTER).
If you select "Auto", an attempt will be made to identify the type of
digital video signals when digital video signals are received.
Item Description
Auto (default) Automatically identifies input digital video
signals
Colour-1 Digital Component Video signals (4:2:2) locked
Digital Component Video signals (4:4:4) locked
Colour-2
Colour-3 Digital RGB signals (16 to 235) locked
Digital RGB signals (0 to 255) locked
Colour-4
4 Press HOME MENU to exit the menu.
when "PC" is selected
("underscan" size screen)