Attaching The Ferrite Core - Pioneer KRP-600A Bedienungsanleitung

Preparation
Note
• Avoid pinching or creating pressure points when routing or
bundling cables.
• The longer a clamp is in place, the better chance of
deterioration. An older clamp is more easily damaged while
being removed and may not be reusable.
• Use the cable clamps as necessary.
• Be careful not to subject any connecting cables to strain.

Attaching the ferrite core

Attach the accessory ferrite core to the end of the display and the
Media Receiver's power cords as shown in the accompanying
illustration. Use the provided cable tie to prevent the ferrite core
from slipping on the cable.
If you do not do this, the flat screen TV will not conform to
mandatory CE standards.
Connecting the SYSTEM cable
Connecting the SYSTEM cable to the Media Receiver
ANT
SAT
Media Receiver (rear)
Caution
• Do not use the SYSTEM cable to connect other equipment to the
flat screen TV.
Connecting the SYSTEM cable to the display
Y P
INPUT 1 INPUT 2 AUDIO R
INPUT 2
LAN (10 / 100) DIGITAL OUT
INPUT 3
HDMI HDMI
OPTICAL INPUT 1 INPUT 3
1
To power outlet
AC power cord
SYSTEM cable
B P R
L
COMPONENT VIDEO
R
L
SUB WOOFER OUT AUDIO OUT SERVICE ONLY
CONTROL
SYSTEM
CABLE
OUT
HDMI
INPUT 4
Note
• The SYSTEM cable comes with the same terminals on both
ends.
• Do not connect an HDMI cable to the SYSTEM CABLE terminal.
• When removing the SYSTEM cable, push and hold the latch on
the connector to release.
4
2
3
Ferrite core
Cable tie
As close as possible
Display (rear)
AC IN
05
To display and
Media Receiver
21
En