Herunterladen Inhalt Inhalt Diese Seite drucken

Using Diseqc Switch; Routing Cables - Pioneer KRP-600A Bedienungsanleitung

Flachbildfernseher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

05
Preparation

Using DiSEqC switch

ANT
Note
• Do not make the following connections:
– using two or more switches
– connecting the Media Receiver and antenna through an STB
– using a motorized antenna

Routing cables

When the speaker is mounted to the display panel:
(KRP-600P)
(KRP-500P)
Speaker cable
20
En
Satellite antenna
SW (DiSEqC)
INPUT 1
SAT (Satellite)
LA
SAT
input terminal
INPUT 3
Speaker cable
Speaker cable
The groove at the bottom is for
speaker cables.
Do not insert the colour sensor
cable in the groove.
Note
• Use the supplied cable clamps as necessary.
• When tidying up your speaker cables, make sure to bundle them
so that they are not subjected to any pressure.
Attaching cable clamps to the main unit
Use the cable clamps as necessary to route the connecting cables.
The diagrams below show the location of the holes on the rear of the
display.
(KRP-600P)
(KRP-500P)
Attaching and removing a cable clamp
Thread the clamp band through the holder [1] and bundle the
cable(s) in the cable clamp. Push and hold the levers then insert the
hook into an appropriate hole [2] on the rear of the display. Pull up
the clamp band to lock.
2
• Confirm that the cable clamp is seated firmly in the panel.
To remove the clamp band, pull and hold the latch to release.
To remove the cable clamp, push and hold the levers then pull it out
from the hole.
Latch
1
Cable clamp
Lever
Lever

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Krp-500aKuro krp-600aKuro krp-500a

Inhaltsverzeichnis