Video Pattern; Screen Protection; Label Input; Sleep Timer - Pioneer KRP-600A Bedienungsanleitung

Useful adjustment settings
(AV source)
Item Description
Disables the Orbiter
Off
Mode 1 Enables the display protection function for any
screen mode other than "Dot by Dot"
(default)
Mode 2 Enables the display protection function for all
available screen modes
(PC source)
Item Description
Off Disables the Orbiter
(default)
Mode 1 Enables the Orbiter
Smoothes text/characters display
Mode 2
4 Press HOME MENU to exit the menu.
To cancel this function, select "Off" in step 3.
Note
• For the Dot by Dot mode, see Selecting a screen size manually on
page 60.

Video Pattern

You can display the Video Pattern screen that also helps eliminate
after-image when it occurs.
1 Repeat steps 1 to 3 provided for
mode (AV source only) .
2 Select "Video Pattern" (/ then ENTER).
A confirmation screen appears.
3 Select "Start" (ENTER).
The Video Pattern screen displays.
Note
• The system is automatically placed into standby one hour after
the Video Pattern screen has started.
• While the Video Pattern screen is on, no buttons operate except
a on the remote control unit and STANDBY/ON on the Media
Receiver. If any of the above buttons is pressed, a message
appears on screen (the Video Pattern function is on).
• To cancel the Video Pattern screen, press a on the remote
control unit, STANDBY/ON on the Media Receiver or Power On
(a) on the display.
• The Video Pattern timer has priority over the sleep timer. When
the Video Pattern timer is on, the sleep timer becomes
ineffective.
Switching the vertical drive

Screen Protection

This function establishes multiple settings for a longer display life.
To select this option, follow the procedure below.
1 Repeat steps 1 to 3 provided for
mode (AV source only) .
2 Select "Screen Protection" (/ then ENTER).
The following settings are automatically entered:
• Auto Size: Wide-Zoom
• Side Mask - Detection: Mode 1
• Orbiter: Mode 1
• Energy Save: Mode 1
• AV Selection: OPTIMUM (when "DYNAMIC" is selected for "AV
Selection")
3 Select "Yes" or "No" (/ then ENTER).
4 Press HOME MENU to exit the menu.

Label Input

You can enter the broadcast name in each channel using the on-
screen software keyboard. For entry, follow the procedure below.
1 Repeat steps 1 to 3 provided for
mode (AV source only) .
2 Select "Label Input" (/ then ENTER).
3 Select an input (/ then ENTER).
The software keyboard appears.
For entry, highlight the desired key, then press ENTER. Up to eight
characters can be entered for each label.
Refer to step 7 for Labeling TV channels on page 36.
K I D S
1 2 3 4 5 6 7 8 9 0
A B C D E F G H
K L M N O P Q R S T
U V W X Y Z ,
& ' ( ) + - *

Sleep Timer

When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "Sleep Timer" (/ then ENTER).
4 Select the desired time (/ then ENTER).
Select "Off" (cancel), "30 min", "60 min", "90 min" or "120 min".
5 Press HOME MENU to exit the menu.
Switching the vertical drive
Switching the vertical drive
Label
I J Delete
Space
. : ; Caps
/ _ @ OK Cancel
11
63
En