Connecting A Personal Computer; Connecting An Amplifier/Av Receiver - Pioneer KRP-600A Bedienungsanleitung

12 Using with other equipment

Connecting a personal computer

Use the PC terminals to connect a personal computer.
Note
• The PC input terminals are DDC2B-compatible.
Media Receiver (front)
USB HDMI
CHANNEL
PHONES INPUT 5 VIDEO
Stereo audio cable
Displaying an image from a personal computer
To watch an image coming from the personal computer, press PC
on the remote control unit or press INPUT on the Media Receiver to
select "PC".
When connecting to a personal computer, the correct input signal
type is automatically detected. If the personal computer image does
not come in clearly, you may need to use Auto Setup menu. See
page 59.
Note
• The PC terminals cannot be used for audiovisual equipment.
Computer compatibility chart
Resolution
720 x 400
640 x 480 (VGA)
800 x 600 (SVGA)
1280 x 720
1024 x 768 (XGA)
1360 x 768 (Wide-XGA)
1280 x 1024 (SXGA)
68
En
KRP-M01
COMMON INTERFACE 2 SATELLITE
L AUDIO R ANALOG RGB  EJECT
COMMON INTERFACE 1 TERRESTRIAL
PC
RGB cable
Personal computer
Frequency
70 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz
60 Hz

Connecting an amplifier/AV receiver

You can enjoy more powerful sound by connecting such audio
equipment as an amplifier/AV receiver or subwoofer to the Media
Receiver.
Media Receiver (rear)
INPUT 1 INPUT 2
LAN (10 / 100) DIGITAL OUT
INPUT 3
OPTICAL
Optical
This connection is not
digital cable
required when
connecting an AV amp
equipped with the
surround function to
AV cable
a subwoofer.
(commercially
available)
Subwoofer
Selecting a digital audio format
Audio signals synchronized with currently displayed images are
output to the AUDIO OUT terminals. However, audio accompanying
the images are output to the SUB WOOFER OUT terminal.
When using the digital audio output terminal (optical), select
settings according to your AV receiver.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "System Setup" (/ then ENTER).
4 Select "Digital Audio Output" (/ then ENTER).
Select "Dolby Digital" (default) or "PCM".
5 Press HOME MENU to exit the menu.
Note
• For details, refer to the operation manual for the audio
equipment to be connected.
• When signals are input from the HDMI terminals, no signals are
output if they are copy guarded.
• While in DTV or SAT mode, no signals are output if they are copy
guarded.
Y P B P R
L
COMPONENT VIDEO
R
AUDIO R L
INPUT 2 SUB WOOFER OUT AUDIO OUT
SERVICE ONLY
CONTROL SYSTEM
CABLE
OUT
HDMI HDMI HDMI
INPUT 1 INPUT 3 INPUT 4
Stereo
audio
cable
AV receiver