Freezing Images; Using The Tools Menu - Pioneer KRP-600A Bedienungsanleitung

06 Watching TV
Press c to select the display mode.
1
Each time you press c, the display mode is switched among 2-
screen, picture-in-picture, and single-screen.
In 2-screen or picture-in-picture mode, press
position of the two screens shown.
The left screen (in the 2-screen mode) or the larger screen (in the
picture-in-picture mode) is the active screen which will be indicated
by "z". The user is allowed to operate picture and sound.
In picture-in-picture mode, press
small screen anticlockwise.
2 To select the desired input source, press the appropriate input
source button.
If watching TV programmes, press P+/P– to change the channel.

Using the TOOLS Menu

You can also select the multiscreen mode from the TOOLS Menu.
1 Press TOOLS.
The TOOLS Menu appears on screen.
2 Select "Split", "Swap" or "Shift" (/).
3 Select a mode (/).
For "Split" mode, select "Off (Single)", "2-screen" or "P-in-P".
The selected mode appears in the center of the TOOLS Menu.
Note
• Refer to the TOOLS Menu on page 77.
• The multiscreen function cannot display images from the same
input source at the same time. If you make such an attempt, a
warning message appears.
• The multiscreen function cannot display images from
combinations of two external input sources ("INPUT 1" to
"INPUT 5", "PC"). It can display images from the following
combinations of input sources.
30
En
to switch the
to move the position of the
– Analogue TV (digital TV or Home Media Gallery) and external
source ("INPUT 1" to "INPUT 5", "PC")
• When you press EXIT, the single-screen mode is restored and
the corresponding menu is displayed.
• When in the 2-screen mode, images displayed on the right
screen may look less fine, depending on the images.
• While in the 2-screen or picture-in-picture mode, the analogue
favourite channel list and the digital channel list are unavailable.

Freezing images

Use the following procedure to capture and freeze one frame from
a moving image that you are watching.
• Before operating with the remote control unit, make sure to select
the TV mode using its SELECT button. See Controlling other
equipment using the supplied remote control unit on page 90.
Important
• Displaying a static image for a long period of time, or for shorter
periods of time everyday, may result in image retention.
Press d.
1
A still image appears on the right screen while a moving image is
shown on the left screen.
Normal image
Press d again to cancel the function.
2
Note
• You cannot freeze the picture when using the 2-screen or
picture-in-picture mode.
• When this function is not available, a warning message
appears.
Still image