Basic Connections; Connecting The Antenna - Pioneer KRP-600A Bedienungsanleitung

Preparation
Important
The colour sensor may not operate properly:
• if attached by methods other than specified above
• if anything blocks light falling on the sensor window
• if light falls on only part of the sensor window
• if the light falling on the sensor window and the panel screen
differs
Note
• If the colour sensor attached to the rear panel does not operate
properly, attach it to the front panel.
• The colour sensor may become hot due to a heat emitted from
the panel. When using it in a high-temperature environment,
attach the colour sensor to the bottom of the front panel.
• Do not use the screws supplied for the speakers.

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Caution
• When the "Aerial Power" setting is on, directly connect the
aerial to the ANT input terminal at the rear of the Media
Receiver. Connecting any device between the aerial and Media
Receiver may cause damage to the device.
Media Receiver (rear)
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
• If "Aerial Power" setting is enabled, use an indoor antenna with
signal amplifier, 5 V 30 mA.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the Media Receiver.
ANT
INPUT 1 INP
LAN (10 / 100)
SAT
INPUT 3
OPTIC
Note
• If the antenna is not connected correctly, the quality of reception
may be impaired. If images are not displaying correctly, check
whether the antenna connection is correct or not.
Connecting the satellite antenna
There are three different connection methods available as shown
below. Select the appropriate menu according to the switch you use.
Setting up satellite TV channels manually
See
details on how the antenna is connected (in a building, for example),
select "SMATV" from "Scan Type" on the "Satellite Setup" menu.
Direct connection to the Media Receiver
ANT
SAT
Using Tone Burst
ANT
SAT
on page 33. If no
Satellite antenna
INPUT 1
LA
SAT (Satellite)
INPUT 3
input terminal
Satellite antenna
SW (Tone Burst)
INPUT 1
LA
SAT (Satellite)
input terminal
INPUT 3
05
19
En