Bluetooth ® Mode - Silvercrest SBLP 4.2 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SBLP 4.2 A1
If a battery has almost run out, this will be indicated by a series
of sounds and the battery LED (6) will flash orange.
WARNING! The device is not covered while charging, as the
device can heat up in the process
8.2 Bluetooth
®
The Bluetooth
player such as your smartphone or MP3 player with the speaker. Once the
two devices are paired, you can play music over the speaker and operate
the main controls of the player remotely using the buttons on the speaker.
Proceed as follows to pair the speaker with your smartphone or player:
 Hold down the on/off button (1) briefly to switch the speaker on. You will
then hear an acoustic signal that gradually increases in volume and the
operating LED (7) will flash blue. The speaker is now in pairing mode.
If a connection has not been established, the speaker will
switch itself off after approximately five minutes.
 Now connect your smartphone or player to the speaker via Bluetooth
do so, refer to your smartphone manual. From the list of devices detected,
44 - English
®
mode
connection allows you to pair a Bluetooth
®
-equipped music
®
. To