Herunterladen Inhalt Inhalt Diese Seite drucken

Panasonic ES-LA93 Handbuch Seite 10

Nass-/trockenrasierer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
If the status lamp blinks or glows
Follow the steps outlined below if the status lamp blinks or
glows during the "Clean/Dry/Charge" course.
Blinks
Glows
Correctly set the
Remove the shaver from the self‑
detergent cartridge
cleaning recharger and then check
and then restart a
that the [CLEAN] lamp has gone
course.
out. (Be careful as the blade may
be hot or wet.) Check that the
water tank is correctly attached,
If the status lamp
the water tank cap is securely
goes out
closed and the self‑cleaning
recharger is placed horizontally.
Continue a course.
When an abnormality
has been corrected
Press and hold
[SELECT] for 
seconds to turn off the
status lamp and then
restart a course.
When the status lamp
goes out
Continue a course.
10
GB
When no abnormality was found
It is time to replace the detergent
cartridge and cleaning liquid
inside the water tank.
Wash away the old cleaning
liquid and then rinse the water
tank. Restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean your
shaver with the self‑cleaning recharger or
the "sonic" vibration turbo‑cleaning mode
when the faucet symbol
appears on
the LCD panel.
1. Disconnect the power cord from the
shaver.
. Apply some hand soap and some
water to the outer foil.
3. Slide the switch lock button downwards
to unlock the OFF/ON switch.
. Press the OFF/ON switch for more
than  seconds to activate the turbo
mode for "sonic" vibration cleaning.
appears on the LCD panel.
After about 0 seconds, it will be
automatically turned off, or you can
turn it off by pressing the OFF/ON
switch.
5. Remove the outer foil section and
press the OFF/ON switch for more
than  seconds to activate the turbo
mode for "sonic" vibration cleaning and
clean it with running water.
6. Wipe off any drops of water with a dry
cloth.
7. Dry the outer foil section and the
shaver completely.
8. Attach the outer foil section to the
shaver.
9. Lubricate the shaver.
4
5
7
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis