Input Signal And Display Status Information - Sony PFM-42B1 Bedienungsanleitung

Watching the Picture
Input Signal and Display Status
Information
Input signal and display status information appears on
the display panel for about five seconds when the
power is turned on or when switching the input signal.
To disable this function, follow the steps below.
1
In the CONFIG (1/2) menu, press v / V to move
the cursor (B) to "DISPLAY" and press ENTER.
The following menu appears on the display panel.
D I S P L A Y
2
Press v / V to set DISPLAY to OFF and press
ENTER.
The DISPLAY function is disabled.
To display the information
Set DISPLAY to ON in step 2 above. The factory
default is ON.
Note
You can display the input signal information and the
time anytime by pressing the DISPLAY button on the
Remote Commander, regardless of the above setting.
The display lasts until you press the DISPLAY button
again to hide it.
The input signal information list
Color system or horizontal/vertical frequency
Signal type
3 1 . 5 k H z / 6 0 H z
I N P U T 1 R G B
26
(GB)
: O N
Time
1 6 : 3 0 : 4 0