Sony PFM-42B1 Bedienungsanleitung Seite 75

Note
When you set the number, use the buttons on the
display unit.
For details about the index number, see "Operating a
Specific Display With the Remote Commander" on page
45 (GB).
es REMOTE MODE
Selects the Remote Commander mode.
TV: The Sony display's or the TV's commander
PJ: The Sony projector's commander
OFF: Disables the remote control.
Note
When you change the Remote Commander mode, use
the buttons on the display unit. You cannot change the
Remote Commander mode with the Remote
Commander.
For details, see "Using Other Remote Commander
Models" on page 47 (GB).
ed REMOTE ONLY
Select ON to disable the control buttons on the display
unit. The display can only be controlled with the
Remote Commander.
To cancel the REMOTE ONLY mode, set REMOTE
ONLY to OFF with the Remote Commander, or press
the MENU button while pressing the 1 (standby)
switch on the display unit. The display turns to the
standby mode and the REMOTE ONLY mode is
cancelled.
The setting in this item is still retained when the AC
power cord is disconnected or when you turn the
display on/off with the Remote Commander.
STATUS menu
This menu is used for displaying the internal status of
the display unit.
ef
S T A T U S
M O D E L N A M E
eg
S E R I A L N o .
O P E R A T I O N
eh
S O F T W A R E
T E M P E R A T U R E
ej
F A N
ek
el
ef MODEL NAME
Indicates the model name.
The description in this section is based on the PFM-42B2E.
: P F M - 4 2 B 2 E
: 2 0 0 0 0 0 1
: 0 0 0 0 0 1 H
: Ver 1 . 0 0
: O K
: O K
eg SERIAL No.
Indicates the serial number.
eh OPERATION
Indicates the total number of hours of operation.
Note
The standby mode is not counted as part of the
OPERATION time.
ej SOFTWARE
Indicates the system software version.
ek TEMPERATURE
Indicates whether the internal temperature of the
display unit is normal.
OK: Normal
NG: Unusual
When the internal temperature is unusual, NG is
displayed and the item flashes in red. The STANDBY
indicator on the 1 (standby) switch / indicator section
also flashes.
Note
The "TEMPERATURE NG" message may appear
when the ventilation holes are blocked or the display
unit is installed in a poorly ventilated location. In this
case, check that the ventilation holes are not blocked
and install the display unit in a well ventilated
location. If the message is still shown, contact your
authorized Sony dealer.
When the STANDBY indicator flashes or NG is indicated,
see "Self-diagnosis Function" on page 45 (GB).
el FAN
Cooling fans are built into this display unit. This item
indicates whether the cooling fans work properly.
OK: Normal
NG: Unusual
When the cooling fans are not working normally, NG
is displayed and the item flashes in red. The
STANDBY indicator on the 1 (standby) switch /
indicator section also flashes.
Notes
• When the "FAN NG" message appears, contact your
authorized Sony dealer.
When the STANDBY indicator flashes or NG is indicated,
see "Self-diagnosis Function" on page 45 (GB).
• The cooling fans detect the display unit's internal
temperature and control the fan rotation. If the
ambient temperature is high, the fan speed increases
and the fan noise will be louder.
Using On-screen Menus
23
(GB)