Electrical Safety - DeWalt DW872 Bedienungsanleitung

E N G L I S H
1 Allen key
1 Vertical clamp
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your professional D WALT toothed chopsaw has
E
been designed for the cutting of variously shaped
metal materials: water and gas pipes, angular iron,
U-profiles, T-bars, rods, bolts, etc. Using the
appropriate cutting blade, it can cut hot and cold
rolled carbon steel, construction steels according to
DIN 1700 (ST33, ST37-2, ST52-3), non-ferrous
metals (i.e. aluminum, brass, copper), stainless steel
and synthetic materials (i.e. PVC). This tool is not
intended to be used in cast-iron, brick, tile or
ceramic materials. The tool is never to be used for
cutting magnesium workpieces.
1 On/off switch
2 Control handle
3 Carrying handle
4 Guard
5 Spindle lock
6 Material clamp
7 Fence
8 Mounting holes
9 Cutting table
10 Allen key

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your tool is double insulated in
accordance with EN 61029; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
DeWALT repair agent or a qualified electrician.
26
DW872.P65
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Fitting a mains plug to 115 V units
(U.K. & Ireland only)
• The plug should be fitted by a competent person.
If you are in doubt, contact an authorized
DeWALT repair agent or a qualified electrician.
The wires are coloured according to the following code:
live
neutral = blue
• Do not connect the blue or brown wire to the
earth terminal in the plug.
Connect as follows:
- brown to terminal marked ÈL|
- blue to terminal marked ÈN|
The plug fitted should comply with BS EN 60309
(BS4343), 32 Amps.
26
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
= brown
10-09-2001, 16:26
.