Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
W hen undertaking prolonged sanding of wood,
and in particular when working on materials
that give rise to dusts that are hazardous to
health, the sander must be connected to a
suitable external dust extraction device.
E nsure that there is adequate ventilation when
working on plastic, paint, varnish etc.
The band file is designed for dry grinding wood,
plastic, metal and filler, as well as painted sur-
faces. Only use the device for dry grinding.
D o not sand materials containing asbestos.
Asbestos is a known carcinogen.
Sanding e.g. lead paint,
some types of wood and metal can release
harmful / toxic dust. Touching or breathing in
these dusts can present a danger to the user or
persons nearby. Use suitable personal protec-
tive equipment such as dust mask, etc. to prevent
this risk.
POISONOUS DUSTS!
Sanding paints containing lead, some types of
wood and metal for example may give rise to
hazardous or poisonous dusts and represents a
risk to the health of the person operating the
device and to anyone near the work area.
Wear safety glasses and a dust protection mask!
S ecurely support the workpiece. Use clamps or
a vice to grip the workpiece firmly. This is much
safer than holding it with your hand.
n ever support yourself by placing your hands
near or in front of the device or the workpiece
surface. A slip can result in injury.
I f a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
A lways work with the mains lead leading
away from the rear of the device.
A void contact with the moving sanding belt.
D o not work on moistened materials or damp
surfaces.
A lways switch on the device before placing it
against the workpiece. After sanding, lift the de-
vice from the workpiece before switching it off.
W hen working always hold the device securely
with both hands. Always keep proper footing
and balance.
S witch the device off and allow it to come to
a complete standstill before you put it down.
General power tool safety warnings / Start-up
W hen taking a break from your work, before
carrying out any tasks on the device itself (e.g.
changing the sanding belt) and when you are
not using the device, always pull the mains plug
out of the mains socket.
Start-up
Note: the small grinding frame
fine jobs, cutting and carving (see Fig. E).
The large grinding frame
applications, slotting and making joints (see Fig. F).
The angled grinding frame
ing and sanding the middle of the work piece and
confined areas. Also use it to smooth bent areas
(see Fig. G).
Installing the grinding frame
Attach the desired grinding frame
Insert the spring
Tighten the adjusting screw
until the grinding frame
with the tool (see Fig. A).
Changing the grinding frame
plug from the mains before working on the band file.
Unscrew the adjusting screw
Be sure not to lose the spring
Remove the grinding frame
Remove the spring
Insert the spring
Attach the desired grinding frame
Tighten the adjusting screw
until the grinding frame
the tool (see Fig. A).
is designed for
12
is suitable for general
8
is suitable for groov-
13
,
8
into the mounting hole.
14
on the device
7
,
,
is in line
8
12
13
RISK OF INJURy! Always un-
from the device.
7
.
14
.
8
.
14
into the mounting hole.
14
,
12
on the device
7
,
is in line with
12
13
,
.
12
13
.
13
GB
9
Werbung
Kapitel
Inhaltsverzeichnis
