Herunterladen Inhalt Inhalt Diese Seite drucken

Start-Up; Installing / Replacing Grinding Tools; Installing Sanding Sleeves; Removing The Sanding Sleeves - Parkside PSR 310 A1 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 63
General power tool safety warnings / Start-up
When working on wood, and especially when
working on materials which could produce
harmful dust, connect the device to a suitable
external dust extraction.
Ensure adequate ventilation when working on
plastics, paint, lacquer, etc.
The sanding brush is designed for dry grinding
areas on wood, plastic, metal and spackle, as
well as painted surfaces. Only use the device
for dry grinding.
Do not work on materials containing asbestos.
Asbestos is considered carcinogenic.
materials such as lead paint, some types of
wood, minerals and metal, can be noxious.
Touching or inhaling this type of dust can pre-
sent a danger to the user or persons nearby.
Wear safety glasses and
a dust mask!
Secure the work piece. Use clamps or a vice to
secure the work piece. This is much safer than
holding it in your hand.
Never place your hands next to or in front of
the device and the surface you are working on,
as slipping poses a risk of injury.
In the event of danger, immediately pull the mains
plug out of the socket.
Always run the mains cable away from the
appliance and toward the rear.
Avoid contact with the sanding sleeve in motion.
Do not work on moistened materials or damp
surfaces.
Always apply the device to the working surface
when switched on. When the task is complete,
lift the appliance off the work piece before
switching it off.
Always firmly hold the device with both hands
whilst working. Ensure you have a solid stance.
Allow the device to come to a complete stop
and switch off before putting it down.
Always unplug from the mains socket before
taking breaks, especially working on the de-
vice (e.g. replacing sandpaper) and during
non-use.
10 GB
TOXIC DUST! Dust from

Start-up

RISK OF INJURY! Always
unplug from the mains before working on the sand-
ing brush.
Installing / replacing grinding
tools (see Fig. A–C)
Activate the spindle lock
and use the hexagonal key
clamping screw
14
Now remove the clamping screw.
Now remove the grinding tool.
Install the respective grinding tool accordingly,
in reverse order.
Activate the spindle lock
and use the hexagonal key
clamping screw
14
Attach the slatted grinding discs
the grinding spindle
First mount the shank
insert the sanding sleeves

Installing sanding sleeves

(see Fig. D)
Follow the direction of slats and turn the sand-
ing sleeve
over the mounting shank
12
the rubber slats are completely covered.

Removing the sanding sleeves

Be sure the mounting shank
the spindle
during removal.
1
To replace or remove an old sanding sleeve
first activate the spindle lock
Then using a rotating motion following the direc-
tion of the slats on the mounting shank
off the sanding sleeve
(until it locks in)
5
to loosen the
10
.
(until it locks in)
5
to tighten the
10
.
directly onto
11
.
1
into spindle
, then
13
1
onto the shank.
12
13
remains inside
13
until it locks in.
5
to pull
13
.
12
until
,
12

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis