Power Led Does Not Light; No Video Display; Characters Are Distorted Or Incorrect; No Available Storage - Intel Mfs5520Vi Bedienungsanleitung

Power LED Does Not Light

Check the following:
•
Did you press the power-on button?
•
Is the compute module operating normally? If so, the power LED might be defective.
•
Is the chassis power LED lit? If not, refer to the troubleshooting section of the Intel
Modular Server System MFSYS25/MFSYS35 User Guide for additional guidance.
•
Is the compute module fully seated in the chassis?

No Video Display

Check the following:
•
Is the power LED lit? If not, refer to
•
Verify that the video monitor is turned on and functioning properly.
•
Verify that the brightness and contrast controls on the video monitor are properly
adjusted?
•
Does this video monitor work correctly if plugged into a different compute module?
•
Verify that the installed processor(s) are validated for use in the compute module.
•
If only a single processor is installed, verify that it is installed in the first processor
socket.
•
Remove and re-seat the processor(s).
•
Verify that the installed memory is validated for use in the compute module.
•
Verify that the installed memory has been populated according to the compute module
requirements.
•
Remove and re-seat the memory.
•
Is the keyboard functioning? Test it by turning the "Num Lock" function on and off to
see if the Num Lock light is working.
•
Is the on-board video controller enabled in the BIOS?

Characters are Distorted or Incorrect

Check the following:
•
Is the video monitor properly adjusted? See the manufacturer's documentation for
operating instructions.
•
Are the video signal and power cables connected properly?
•
Does this video monitor work correctly if plugged into a different compute module?

No Available Storage

Check the following:
®
Intel Compute Module MFS5520VI User Guide
"Power LED Does Not Light" on page
®
97.
97