Preparing Eggs With Various Hardness Levels At The Same Time - Silvercrest H-3278 Bedienungsanleitung

RP46551Block4.book Seite 6 Dienstag, 19. Januar 2010 9:06 09
- Do not touch the hot surfaces on the
appliance (e.g. the lid). Only hold the
hot lid 1 and the egg tray 2 by the han-
dles.
- Do not remove the lid 1 while the eggs
are boiling. Open the lid with great
caution only after the signal sound (if
necessary, using a towel) because hot
steam will escape.
- Since the handle of the egg tray 2 gets
hot, use a towel or oven gloves to
remove it.
1. Insert the power plug in an easily
accessible socket with earthing
contacts.
2. Switch the appliance on by setting the
on/off switch 6 to I. The red pilot lamp
6 indicates that the appliance is
heating up.
3. The water is now boiling and the eggs
are boiled. The end of the boiling time
is indicated by a signal tone. Now
switch the appliance off by setting the
on/off switch 6 to 0.
4. Carefully remove the lid 1 from the
appliance using the handl. Place the
lid on a heat-resistant surface
because it is very hot.
5. Use the handl to remove the egg tray
2 and run the eggs under cold water
to cool them.
After boiling
DANGER: Disconnect the power
plug from the wall socket every
time you have boiled eggs.
• Leave the appliance to cool down,
before you ...
... pour away any water left,
... Pour in new water,
... Clean the appliance,
... Tidy away the appliance.
6
GB
5. Preparing eggs with
various hardness
levels at the same time
You can use this egg boiler to prepare
eggs with various levels of hardness at the
same time.
1. Prepare all eggs as usual.
2. First of all, prepare all eggs with the
hardness setting for the softest eggs.
3. When the signal indicates the end of
the boiling time, switch the appliance
off, carefully remove the lid 1, remove
the eggs that should not boil any
further and cool them with cold water.
4. The rest of the eggs remain in the egg
boiler.
5. Put the lid 1 back on.
6. Use the hardness controller 5 to set
the desired subsequent boiling time
for the remaining eggs. The small
egg symbols roughly correspond to
the following subsequent boiling times:
: Difference between soft and
medium or medium and hard
: Difference between soft and hard
TIP: Here, too, there are deviations
resulting from varying numbers and
sizes of eggs. Adjust the setting
accordingly.
7. Switch the appliance on again.
8. When the signal indicates the end of
the boiling time, switch the appliance
off, carefully remove the lid 1, remove
the remaining eggs and cool them
with cold water.