Using Ground Coffee - Saeco Mini bar Bedienungsanleitung

5 COFFEE BREWING
Warning! During the coffee brewing, do not
remove the pressurized porta lter by manually
turning it clockwise. Danger of burns.
•• During this operation, the buttons (15 - 16) may  ash on
and off; this is to be considered as standard and not a
faulty operating mode.
•• Before using the machine, make sure that the hot water/
steam knob (4) is closed and that there is enough water
in the tank.
•• (Fig.3) - Press the ON/OFF button (2).
•• Wait for the buttons (15 - 16) to be permanently on. The
machine is now ready for coffee brewing.
5.1

Using ground coffee

•• (Fig.7) - Insert the pin (13) into the pressurized porta lter
(10).
•• (Fig.8A) - Insert the adapter (12) into the pressurized
porta lter (13), then insert the  lter (11).
•• (Fig. 11) - Insert the porta lter into the brew unit from the
bottom (6).
•• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
•• (Fig.14) - Preheat the pressurized porta lter by pressing
the button (15). Water will spill out of the pressurized
porta lter (this has to be done only for the  rst coffee).
•• Water dispensing will stop automatically.
•• (Fig.16) - Remove the porta lter from the machine by
turning it to the left and pour out any water left. As the
machine is  tted with the special  lter (11), there is no
need to change the  lter to make one or two coffees.
•• (Fig. 9A) - Add 1-1.5 measuring scoop for single coffee
and 2 measuring scoops for double coffee. Remove any
coffee residues from the rim of the  lter.
•• (Fig.11) - Insert the porta lter (10) into the brew unit from
the bottom (6).
•• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
•• (Fig.13) - Take 1 or 2 preheated cups and place them
under the pressurized porta lter. Make sure that they are
correctly placed under the coffee dispensing holes.
•• (Fig.14) - Press:
- The button (15) to brew 1 coffee
- The button (16) to brew 2 coffees.
•• When the programmed quantity of coffee has been
obtained, brewing will stop automatically. Remove the
coffee cups. (Fig.15).
•• (Fig.16) - Wait a few seconds after brewing, then remove
the pressurized porta lter and empty the remaining coffee
grounds.
Note for cleaning: keep the filter of the
pressurized porta lter clean by removing it from
its seat and washing it with drinking water (Fig.17). Wash
the adapter and the pin of the porta lter, then wash the
porta lter itself.
•• 20 ••
5.2 Using Coffee Pods
•• (Fig.10) - By using a coffee spoon, remove the ground
coffee  lter (11) and the adapter (12) from the pressurized
porta lter (10).
•• (Fig.7) - Remove the pin (13) from the pressurized
porta lter (10).
•• (Fig.8B) - Insert the pod  lter (14) into the pressurized
porta lter (13).
•• (Fig.11) - Insert the porta lter into the brew unit from the
bottom (6).
•• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
•• (Fig.14) - Preheat the pressurized porta lter by pressing
the button (15). Water will spill out of the pressurized
porta lter (this has to be done only for the  rst coffee).
•• Water dispensing will stop automatically.
•• (Fig.16) - Remove the pressurized porta lter from the
machine by turning it to the left and pour out any water
left.
•• (Fig.9B) - Insert the pod into the porta lter and make sure
the paper of the pod does not overhang the porta lter.
•• (Fig.11) - Insert the porta lter into the brew unit from the
bottom (6).
•• (Fig.12) - Turn the porta lter from left to right until it locks
in place.
•• Take 1 preheated cup and place it under the porta lter;
make sure that it is correctly placed under the coffee
dispensing holes.
•• (Fig. 14) - Press the button (15) for 1 coffee.
•• When the programmed quantity of coffee has been
obtained, brewing will stop automatically. Remove the
coffee cups. (Fig.15).
•• (Fig.16) - Wait a few seconds after brewing, then remove
the porta lter and dispose of the used pod.
Note for cleaning: keep the filter of the
pressurized porta lter clean by removing it from
its seat and washing it with drinking water (Fig.17). Then
wash the porta lter itself.
5.3 Programming the Quantity of Coffee
It is possible to preset the quantity of coffee to be brewed
by pressing the buttons (15) or (16).
The quantity of coffee can only be programmed
for the button (15) (min. 25cc, max. 180cc).
By pressing the button (16), you will have twice the
quantity programmed by the button (15).
•• To start programming, insert coffee into the porta lter as
shown in Sections 5.1 and 5.2.
•• Place a cup under the brew unit (4).
•• (Fig. 14) - Press the coffee brew button (15) for a few
seconds. After 3 seconds, the machine will start brewing
coffee.
•• When the desired quantity of coffee is in the cup, release
the button (15).