Yamaha 2006-2012 FJR 1300 Montageanleitung Seite 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Fitting the screen to the motorcycle:
1. Remove the covering of the screw attachments after unscrewing
out both screws under the front edge of the
Attention: When unscrewing out the Philips screws, hold the
cladding shield to stop it from falling.
2. Place the new cladding shield into position and fix with the
original screws but not too tightly screwed.
3. The cover of the original screen is no longer needed in assembly.
4. Edge protection is not necessary due to the sufficient material
thickness.
5. The enclosed general operating license must be carried.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
spirits to clean the screen as they will damage it.
1
MO UN T IN G IN STR UC T ION S
YAMAHA FJR 1300 06-12
2
cladding disk.