Operation - Silvercrest SDM 1500 C2 Bedienungsanleitung

NOTE
If the mains water in your location is rated as hard, it is recommended that
you mix the mains water with some distilled water. Otherwise, the jets for
the steam blast function could calcify (become blocked) prematurely.
To extend the optimal steam blast function, mix mains water with
distilled water according to the table:
Water hardness
The water hardness level can be queried at your local water works.
4) Attach and hand-tighten the clamp.
5) Turn the water tank 8 around again and place it back onto the main unit 3:
First fi t the lower part into the main unit 3 and then fl ip the top part into the
device. Push it fi rmly into place so that the water tank 8 audibly clicks into
place and sits fi rmly on the main unit 3.

Operation

CAUTION – PROPERTY DAMAGE!
► If you are not sure whether the fl oor is suitable for cleaning, please carry
out a tolerance test using a concealed part of the fl oor.
► Always comply with the cleaning instructions of the carpet manufacturer.
Before cleaning, check also whether the carpet is suitable for steam clean-
ing.
Never use the appliance without a pad 6 on the steam foot 5.
►
Otherwise the fl oor could get scratched!
Never operate the appliance without water in the water tank 8!
►
The pump could overheat and be damaged!
NOTE
► Before you clean the fl oor with the steam mop, we recommend that you
vacuum the fl oor to remove any loose particles of dirt.
Once the appliance is assembled and fi lled with water:
1) Press and hold in the "Handle" release button 1 and fl ip the handle up-
wards so that it clicks into place.
SDM 1500 C2
very soft/soft
medium
hard
very hard
Ratio of distilled
water to
tap water
0
1:1
2:1
3:1
GB │ CY │
9 ■