ECG EDF 4527 QWA++ Bedienungsanleitung Seite 98

Problem
Foam in the
dishwasher tub
Coloured interior of
the tub
The dishes and cutlery
are not clean
GB
Spots and fi lm on
glasses and cutlery
Coating on glassware.
Yellow or brown fi lm
on interior surfaces
White coating on the
inner surface.
Detergent dispenser
lid does not close
properly
Detergent remained
in the detergent
dispenser trays.
Steam
Black or gray spots on
the dishes.
Water remains on the
bottom of the sink
Water leak from the
dishwasher
98
Possible cause
Wrong detergent
Rinse aid overfl ow
Detergent with dye was used.
Unsuitable program was
selected
Improper loading of dishes in
the baskets
1. Very hard water
2. Low temperature
3. Too many dishes in the
dishwasher
4. Incorrectly loaded dishes
5. Old or wet detergent
6. Empty rinse aid dispenser
7. Incorrect dosage of the
detergents
The combination of soft water
and an excessive amount of
detergent.
Coff ee or tea spots
Metal deposits in water can
cause pervasive coating
Hard water containing
minerals
The residue of detergent
clogged the lid catch.
The dishes blocked the
dispenser trays.
This is normal
Aluminium utensils have
rubbed against other dishes.
This is normal
Overfi lling dispenser or spill of
the rinse aid
The dishwasher is not in level
position
Corrective action
Use only detergents designed for automatic dishwashers. In
the case of foam, open the dishwasher door and let the foam
evaporate. Pour into the tub about 4.5 litres of cold water.
Close the dishwasher and run the program "soaking" to drain
the water. Repeat if necessary.
Wipe the spilled rinse aid immediately.
Make sure that the detergent used does not contain dyes.
Select a more intensive program.
Make sure that the eff ects of the detergent dispenser and
spray arms are not blocked by large dishes.
Removing spots from glass:
1. Remove all metal cutlery
2. Do not replenish detergent
3. Select the longest program
4. Run the dishwasher and let it run for about 18 to 22 minutes
before coming into the main wash.
5. Open the door and pour in 2 cups of white vinegar.
6. Close the door and let the dishwasher fi nish the program. If
the vinegar does not help: Repeat the above procedure, but
instead of vinegar, use 1/4 cup (60 ml) of citric acid crystals.
If you are using soft water, use less detergent for glass washing
and select a shorter program.
Use a solution of 1/2 cup of bleach and 3 cups of water and
remove stains manually.
ATTENTION!
After completing the program, wait before cleaning the
interior surface for at least 20 minutes to let the heating
elements cool down. Otherwise, there is a risk of burns.
Contact your water supplier with a request to install a special
fi lter.
To clean the interior, use a sponge soaked in detergent for
dishwashers. Use rubber gloves. Never use any other cleaner
than for dishwasher to prevent formation of foaming or suds.
Remove the residue of the detergent from the catch.
Rearrange the dishes.
Certain amount of steam comes through the ventilation
openings during drying and draining of water.
To remove these stains use a mild abrasive cleaner.
Small amount of water on the bottom of the sink prevents
drying of the water seal.
Make sure that you do not overfi ll the rinse aid dispenser.
Spilled rinse aid can cause excessive foaming and may lead to
overfl ow. Wipe the spilled rinse aid using wet cloth.
Make sure that the dishwasher is in level position.