Operating The Device Safely - Dometic COOLMATIC RPD50 Montage- Und Bedienungsanleitung

RPD50
• If the refrigerator is connected to the DC socket: Disconnect the
refrigerator or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
• The refrigerator is not suitable for storing substances which are caustic
or contain solvents.
• Keep the drainage outlet clean at all times.
• Do not open the refrigerant circuit under any circumstances.
• Never transport the device in a horizontal position, so that no oil can
leak out of the compressor.
• Make sure that the refrigerator circuit is not damaged during transpor-
tation. The refrigerant in the refrigerator circuit is highly flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
• Set up the device in a dry location where it is protected against splash-
ing water.
2.2

Operating the device safely

D
DANGER!
• Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
!
CAUTION!
• Before starting the device, ensure that the power supply line and the
plug are dry.
• If you connect the device to a battery, make sure that no food comes
into contact with the battery acid.
A
NOTICE!
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for that purpose.
• Do not place it near naked flames or other heat sources (heaters, direct
sunlight, gas ovens etc.)
• Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
EN
Safety instructions
9