Changing The Door Hinge - Dometic COOLMATIC RPD50 Montage- Und Bedienungsanleitung

RPD50
6.3

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather than the
right.
To change the door hinge, proceed as follows (fig. 4, page 4):
➤ Remove the upper door hinge (fig. 4 1, page 4).
➤ Carefully lift out the door.
➤ Remove the threaded pins (fig. 4 2, page 4).
➤ Pull the locking hook (fig. 4 3, page 4) off the rod.
➤ Remove the locking plate (fig. 4 4, page 4) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (fig. 4 3, page 4) back on the rod.
➤ Detach the top and bottom lock holders (fig. 4 5, page 4) on the left side.
➤ Detach the top and bottom door hinges (fig. 4 1, page 4) on the right side.
➤ Fasten the top and bottom door hinges (fig. 4 1, page 4) to the left side.
➤ Fasten the top and bottom lock holders (fig. 4 5, page 4) to the left side.
6.4 Changing the decorative plate
You can change the decorative plate on your refrigerator to improve the appear-
ance.
This is how to change the decorative plate:
➤ Remove the screws 1 and 3 (fig. 5 1 and 3, page 4).
➤ Remove components 2 and 4 (fig. 5 2 and 4, page 4).
➤ Pull down the old decorative plate out of the door frame.
Caution: there is a risk of injury!
➤ Put the new decorative plate in the door frame.
➤ Fit the components 2 and 4 (fig. 5 2 and 4, page 4) back on the device.
➤ Fasten the screws 1 and 3 (fig. 5 1 and 3, page 4).
EN
Setting up and connecting the refrigerator
13