Setting Up And Connecting The Refrigerator; Removing The Transport Protection - Dometic COOLMATIC RPD50 Montage- Und Bedienungsanleitung

Setting up and connecting the refrigerator

6 Setting up and connecting the
refrigerator
6.1 Setting up the refrigerator
In continuous operation, the air humidity may not exceed 90 %.
Set up the refrigerator in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens or hot water pipes. Do not let it stand in the full sun.
The refrigerator must be positioned so that heated air can dissipate easily. Therefore
make sure there is adequate ventilation (fig. 2, page 3).
No. in fig. 2,
Explanation
page 3
1 Hot waste air
2 Cold intake air
3 Condenser
4 With cover panel 50 mm above
6.2

Removing the transport protection

The refrigerator has a locking mechanism to protect it during transport. The follow-
ing settings are possible:
• Position 1 (transport lock): (fig. 3 1, page 4) The door is locked and secured. To
open the door, turn the bolt to position 2.
• Position 2: (fig. 3 2, page 4) The door can be opened.
• Position 3 (VENT position): (fig. 3 3, page 4) The door is slightly open, but
fixed. Use this position, for example, if you are not going to use the device for a
long time.
12
RPD50
EN