Setting The Time; Adjusting The Volume - Silvercrest 279334 Bedienungsanleitung

SilverCrest SMBC 30 A1

9.2. Setting the time

To set the time, proceed as follows:

Switch the Micro Stereo System standby.

Keep the CLOCK button [43] on the remote control pressed until the hours display flashes.

Press the ▲ button [9] or the ▼ button [10] on the Micro Stereo System or the ▲ button
[52] or ▼ button [48] on the remote control to set the hours.

Press the CLOCK button [43] on the remote control. The minutes start flashing.

Press the ▲ button [9] or the ▼ button [10] on the Micro Stereo System or the ▲ button
[52] or ▼ button [48] on the remote control to set the minutes.

Press the CLOCK button [43] on the remote control to confirm the input.
In standby mode, the Micro Stereo System shows the time on the display [2]. While it is switched
on, you can display the time for a few seconds by pressing the CLOCK button [43] on the
remote control.
The clock can also be synchronised automatically from the RDS signal of a radio station. Proceed
as follows:

Switch the Micro Stereo System standby.

Press the INFO button [28] on the remote control to toggle between "TS ON" and "TS
OFF".
TS ON = The clock is synchronised automatically (enabled upon factory delivery).
TS OFF = The clock is not synchronised automatically and must be set manually.

Switch the Micro Stereo System to Radio mode.

Tune in a station that broadcasts an RDS signal. This synchronisation may take a few minutes.
If the clock gets synchronised with the wrong time, select "TS OFF" and then set
the time manually.

9.3. Adjusting the volume

You can use the Volume control [11] on the Micro Stereo System or the Increase volume
[34] or Decrease volume [35] buttons on the remote control to adjust the volume.
The currently set volume level is shown on the display [2].
44 - English